Polyjacking vs. Mudjacking in Kansas City — What’s the Difference?
Polyjacking vs. Mudjacking in Kansas City — What’s the Difference?
Get a Free Leveling EstimateIf you have a sunken driveway, settled sidewalk, or uneven patio in Kansas City, you’ve probably seen two options advertised: mudjacking and polyjacking (also called polyurethane foam lifting). Both inject material under a sunken slab to lift it — but that’s where the similarity ends. Here’s exactly how they differ, what each costs, and which is right for your situation.
How Mudjacking Works
Mudjacking (also called slabjacking) is the older method. Contractors drill 1.5–2″ holes through the slab, then pump a slurry of Portland cement, water, and sometimes soil or fly ash beneath the slab under pressure. The slurry fills voids and hydraulically lifts the concrete back to grade. Once the slurry cures (1–2 days), the holes are patched and the slab is usable.
Mudjacking pros:
- Lower cost — typically $3–$6/sq ft vs. $5–$10/sq ft for polyjacking
- Uses natural, environmentally neutral materials
- Proven technology — has been used for 80+ years
Mudjacking cons:
- Heavier fill material — adds 100+ lbs/cubic foot of load back onto the soil
- Larger drill holes (1.5–2″) are more visible after patching
- Slurry can wash out over time, causing re-settling
- Not suitable for areas with water infiltration (slurry erodes)
- 24–48 hour cure time before full traffic
How Polyjacking Works
Polyjacking uses two-component polyurethane foam injected through much smaller holes (⅛”). The foam expands 20–30× its liquid volume within seconds, filling voids and lifting the slab. The foam cures in 15–30 minutes, allowing traffic in under an hour.
Polyjacking pros:
- Smaller holes (⅛” vs. 1.5–2″) — nearly invisible after patching
- Fast cure — drive on it in 1–2 hours
- Lightweight — doesn’t add significant load to the subbase
- Waterproof — doesn’t erode or wash out
- More precise lift control
Polyjacking cons:
- Higher cost — $5–$10/sq ft vs. $3–$6 for mudjacking
- Not all contractors have polyurethane injection equipment
Side-by-Side Comparison
| Factor | Mudjacking | Polyjacking |
|---|---|---|
| Cost (KC 2025) | $3–$6/sq ft | $5–$10/sq ft |
| Hole size | 1.5–2 inches | ⅛ inch |
| Cure time | 24–48 hours | 15–30 minutes |
| Weight added | Heavy (soil/cement slurry) | Very light (foam) |
| Water resistance | Can erode over time | Fully waterproof |
| Longevity | 5–10 years typical | 10–20 years typical |
| Best for | Large areas, tight budgets | Precision, driveways, areas with water |
Which Is Right for Kansas City Conditions?
Kansas City’s clay soil and freeze-thaw climate make polyjacking the better long-term choice for most applications:
- Driveways: Polyjacking — waterproof foam holds up better to water infiltration in KC’s wet springs
- Garage aprons: Polyjacking — small holes and fast cure; vehicles back in the same day
- Large warehouse or commercial floors: Mudjacking may be cost-effective when precision is less critical and areas are interior/protected
- Sidewalks: Either works; polyjacking’s small holes are less visible in high-visibility areas
💡 Neither method works when the concrete slab itself is cracked through, severely damaged, or when the subbase has completely failed. In those cases, full replacement is the right call — lifting a broken slab just moves the problem.
Frequently Asked Questions
How long does polyjacking last in Kansas City?
When done on a structurally sound slab with good underlying soil, polyjacking typically lasts 10–20 years. The foam itself doesn’t degrade, but if the underlying soil issue isn’t addressed (drainage, erosion, compaction), the slab can resettle.
Is polyjacking worth the extra cost over mudjacking?
For most residential applications in Kansas City, yes. The waterproof foam holds up better to KC’s wet conditions, the smaller holes are nearly invisible, and the faster cure time is a major convenience. The price premium is typically $2–$4 per square foot.
Can you polyjack a cracked driveway?
It depends. Polyjacking lifts and levels — it doesn’t bond cracks together. If the slab has surface cracks but is structurally intact (not broken into pieces), lifting it may work. If the slab is broken into multiple independent pieces, you’ll need replacement. We assess every slab before recommending a method.
Free Concrete Leveling Assessment — Kansas City
We’ll evaluate your sunken slab and tell you whether leveling or replacement makes more sense — with a written estimate for both options.
